The all NEW Hurricane Vacuum from Black Box Vac is better than ever.. This unit can be used with any type CNC Router. It is designed to sit on the included stand. This stand supports the system above the floor allowing the exhaust port to flow free, the stand also acts as a muffler to reduce the noise made by the unit.

The NEW design offers:

- New Steel construction with a black powder coated finish
- New Standard noise reducing stand
- New Standard filter system
- Standard Vacuum gauge
- Easy to access exhaust filters on back of unit
- Easy one port hookup
- New Smaller footprint

Most customers sit the system under the frame of their routers, if it will fit. If not they just sit it to the back or side. The unit is very versatile.

This machine operates off 220V 30A power.

The Hurricane Vac System is design ed and built in the USA!

Specifications:
Power requirements: 1 PH 220-230V @30 Amps
Unit Size: 35"W x 17.5"D x 17.5"H
Approximate CFM’s: 400
Approximate inHg: 9.5
Cord Length: 6 foot
Plug Type: Pass & Seymour 30 Amp 250-Volt Locking Plug


More Info:
The Hurricane has 4 motors that are ran in two vacuum chambers. Two motors in one and two in the other. The Box is designed so the user can switch from using two motors to all 4. This is done by using the start buttons on the side of the unit. The switches are labeled as Main and Secondary. The main switch should always be used first. If only 2 motors are adequate for the job the main should be the one used. This is due to a baffle that is located between the two chambers. This baffle engages and disengages depending on the selection of the switches from the user.

The Hurricane System comes standard with one 3" inlet port. This port is located on the side of the box for easy installation to your machine. We also offer an option for a set of (4) Gate Valves (part # BBV-4VK) if you need to separate your zones on your table.